Release 1 34-ST-25-19 RMA 3000 Remote Meter Assemblies User Manual
6/04
vii
CE Conformity (Europe) Notice for Remote Meter Assemblies
(RMA)
About Conformity and Special Conditions
This product is in conformity with the protection requirements of 89/336/EEC, the EMC Directive, and of
94/9/EC, the Explosive Atmospheres (ATEX) Directive. Conformity of this product with any other “CE
Mark” Directive(s) shall not be assumed.
Deviation from the installation conditions specified in this manual, and the following special conditions,
may invalidate this product’s conformity with the EMC Directive.
• Shielded, twisted-pair cable such as Belden 9318 must be used for all signal/power wiring.
• The shield must be connected to ground at only one end of the cable. Connect it to the power supply and
the meter sides of the wiring; leave the shield insulated at the transmitter side of the wiring.
ATTENTION
The emission limits of EN 50081-2 are designed to provide reasonable protection against
harmful interference when this equipment is operated in an industrial environment. Operation
of this equipment in a residential area may cause harmful interference. This equipment
generates, uses, and can radiate radio frequency energy and may cause interference to radio
and television reception when the equipment is used closer than 30 meters (98 feet) to the
antenna(e). In special cases, when highly susceptible apparatus is used in close proximity, the
user may have to employ additional mitigating measures to further reduce the electromagnetic
emissions of this equipment.
To Next Page
Loading...
Need help?
General
