18
4
10
1
10
7
20
M
LED Pattern Condition Action Required
Normal mode
Address zero
trouble
Factory default
Waiting for a profile
The gateway is in the mesh and may be in trouble Refer to the FACP to identify the
trouble and possible solution
The gateway address is set to zero
Gateway is starting up without a profile
Gateway is in factory default mode
Legend
Number of blinks
LED color
Interval between blink patterns
Duration of LED state
Indicates value is approximate
Two blinks in this pattern
First blink is green, Second is yellow
7 seconds between blink patterns
Will transition to next state after
approximately 20 minutes
Example:
ledgate2_4.0.wmf
Ensure all devices in the mesh
have a valid address
Use SWIFT Tools to assign a profile
Figure D.2 Gateway LED Patterns (Continued)
Rescue mode
Gateway and the mesh are searching for any
device that is not in the mesh network with the
same profile. The gateway may be in trouble
12
3
M
Normal mode/
background mesh
restructuring
Rescue mode
Gateway is in the mesh
Gateway and the mesh network are searching for
any device that is not in the mesh network with the
same profile
18
12
3
M
Mesh update ready
Received command from SWIFT Tools to start
a firmware update
Solid
V
All units are in seconds. “M” indicates Minute. “V” indicates Variable.
5
M
6
1st mesh
restructuring
Mesh is formed and initializing Ensure all devices in the mesh have a
valid address
To Next Page
Loading...
Need help?
General
