To Next Page

To Previous Page

Setup Menus (cont’d)

Adjust the Screen Timeouts

Settings include:

• Backlight Off After X time (turns the backlight Off after the selected time has expired)

• Return To Homepage After X time (returns to “Home” screen after the selected time has expired)

• Auto Slideshow After X time (if enabled, begins the slide show after selected time has expired)

To select the desired screen timeouts, do the following:

Press the Setup and Disp & Audio Setup icons; enter an authorized code, if required.

Press the desired selection from the drop-down list displaying the time period for each option and press

the Save icon. If changes are made, when you exit a pop-up window displays: “Information

Settings saved“

Clean Screen

With the exception of normal cleaning, the keypad is maintenance free.

Press the Setup , Disp & Audio Setup

and

CLEAN SCREEN icons. A pop-up window

displays

"Touch Screen has been disabled so that you may wipe the screen clean. Please use a damp, soft cloth.

DO NOT use any liquids, sprays, or ammonia-based cleansers. Press CONTINUE to disable touchscreen."

*Panics cannot be initiated during this process*

Press Continue or Cancel to exit or press the Save icon.

NOTE: When the "Continue" icon is pressed the message "Touch Screen Disabled for =30 Seconds"

is displayed. During these 30 seconds the touch screen should be wiped clean of fingerprints

using a mild soap solution and a soft cloth. When the counter reaches zero, the window

automatically closes and the touch screen is active.

IMPORTANT: Do not use an abrasive cleaning agent or abrasive cloth when cleaning Tuxedo or

damage to the touch-screen may occur.

The Emergency screen cannot be accessed while running in the clean screen mode.

Panel Configuration

The Panel Configuration screen displays the configuration of the panel and details of your system. The

Panel Hardware, Panel Version, Cal Support, No. of Partitions, Home Partition, Sequence Number, No.

of Outputs and No. of Zones are displayed.

To view the panel configuration, do the following:

Press the Setup icon and System setup icons.

Press the CS Setup and enter your authorized code. Press the Panel Configuration icon; the

"Panel Configuration" screen is displayed. If correct, press Back to return to “System” setup screen.

NOTE: Delete clears the configuration from the keypad and reloads the panel configuration into the

keypad from the panel. After you press Delete, a confirmation screen is displayed.

Honeywell TUXWIFIS Installation And Setup Guide

Other manuals for Honeywell TUXWIFIS