– 27 –
Macro Key Programming & Usage
About Macro Keys
The “A”, “B”, “C” or “D” keys can be used to automatically activate a series of
commands of up to 16 keystrokes, if programmed for this function. These keystrokes,
as a group, are called “macros” and are stored in the system's memory.
• Typical macro functions can include:
- Arming sequences: STAY, NIGHT-STAY, INSTANT, or AWAY
- Bypassing particular zone(s)
- Activating relay(s) for turning on (or off) lights, fans, etc.
• Up to four (VISTA-20P Series) or two (VISTA-15P Series) macros can be
assigned – but no more than one macro to a key.
• Macros can be activated only by users with authority levels authorized to
perform the macro’s function.
NOTE: The installer must activate the desired function key (using *57 Function
key Menu Mode) before macros can be assigned.
See the chart at the back of this manual for the key(s) assigned for macros.
1. + [#] + [6] + [6]
(Security Code)
Alpha Display:
∗∗∗∗DISARMED∗∗∗∗
READY TO ARM
2. Enter the macro number (1-4 for VISTA-20P Series; 1-
2 for VISTA-15P Series) to be programmed at the
“Select Macro?” prompt. Remember, only one macro
can be assigned to each key.
SELECT MACRO
1-4 0
3. If a macro has been previously defined, the keystrokes
are shown on the bottom line of the display; otherwise
the display is blank.
To exit this mode (and keep the existing macro
definition), press any key except the [∗] key. The
system returns to normal mode.
To define a macro for the selected key, press [∗] and
continue with the next prompt.
MACRO DISPLAY
Enter the first of the series of desired commands, (do
not include your user code), then press/hold the “D” key
for at least two seconds to complete the first command.
This key terminates each command, and appears as an
“F” in the keypad display.
MACRO PGM
National Security Systems Inc (800) 457-1999
To Next Page
Loading...
Need help?
General
