Honeywell Voyager XP 1472g2D User Manual

Reading Techniques
The view finder projects an aim-
ing dot that should be centered
over the bar code, but it can be
positioned in any direction for a
good read.
Hold the scanner over the bar
code, pull the trigger, and center
the aiming dot on the bar code.
The aiming dot is smaller when
the scanner is closer to the code
and larger when it is farther from the code. Hold the scanner
close to smaller bar codes, and farther away from large bar
codes to get a proper read.
If the bar code is highly reflective (e.g., laminated), you may need
to tilt the scanner at an angle so the bar code can be scanned.
Note: If the scanner razzes when scanning a bar code, the link
has not been established. If the scanner beeps once, the
link has been established.
Standard Product Defaults
The following bar code resets all standard product default set-
tings.
Note: PDF and 2D bar codes can only be read by Voyager model
1472g2D and cannot be read by model 1472g1D.
Standard Product

Honeywell Voyager XP 1472g2D Specifications

General

Connectivity	Bluetooth
Environmental Sealing	IP42
Operating Temperature	0°C to 50°C (32°F to 122°F)
Weight	210 g (7.4 oz)
Motion Tolerance	Up to 400 cm/s (157 in/s) for 13 mil UPC at optimal focus
Expected Duration of Operation	14 hours
Expected Charge Time	4.5 hours
Storage Temperature	-40°C to 70°C (-40°F to 158°F)
Humidity	0% to 95% relative humidity, non-condensing
Light Levels	0 to 100, 000 lux
Battery	Lithium-ion battery
Drop Specification	Designed to withstand 30 drops from 1.8 m (6 ft) to concrete
Decode Capabilities	Reads standard 1D, PDF, 2D
Number of Scans	Up to 50, 000 scans per charge
Scan Angle	Horizontal: 40°; Vertical: 30°