14
1
Check filter bag.
Change, if full.
Note: When using the vacuum
to pick up very fine dust, such
as sawdust or drywall dust, it
will be necessary to replace
the bag and clean the filters
at more frequent intervals to
maintain maximum pick-up
power. Fine dust will clog
bag pores and reduce suction,
prior to bag becoming full.
Maintenance
Performance Indicator
If color changes from green to red, check for the following conditions:
2
Check for clogs in
nozzle, hose, and
bag inlet. Clear any
obstructions.
THERMAL PROTECTOR STATEMENT
A thermal protector has been designed into your cleaner to protect it from overheating.
When the thermal protector activates the cleaner it will stop running.
If this happens proceed as follows:
1. Turn cleaner OFF and unplug it from the electrical outlet.
2. Check fullness of bag, change if needed.
3. Inspect the air path for any obstructions. Clear obstructions if present.
4. When cleaner is unplugged and motor cools for 30 minutes, the thermal protector will deactivate
and cleaning may continue.
If the thermal protector continues to activate after following the above steps, your cleaner
needs servicing.
WARNING TO REDUCE THE RISK OF PERSONAL INJURY–UNPLUG BEFORE CLEANING OR SERVICING.
Any other servicing should be done by an authorized service representative.
If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into
water, take it to a service center prior to continuing use.
Alerts the user of a clog or full bag for optimal cleaning.
To Next Page
Loading...
Need help?
General
