17
HOW TO CHECK FOR CLOGS & FILTERS
1
To remove, push down on tab
and pull out filter housing.
2
Lift out and hand rinse in cold
water under low pressure. Rinse
only with open side facing up.
Allow to dry and reposition into
filter housing, pushing firmly on
tab to snap into place.
Filters
WARNING TO REDUCE THE RISK OF PERSONAL INJURY – UNPLUG BEFORE CLEANING OR SERVICING. DO NOT
OPERATE VACUUM WITHOUT BOTH INLET FILTER AND FINAL FILTER IN PLACE.
HEPA Media Final Filter
The final filter assists in the filtration process to return cleaner air to the room.
REPLACEMENT FILTER
Rinse HEPA Media Final Filter every 2 months. Check for wear of media and replace
if pleats are damaged. Change filter regularly to maintain maximum performance.
Part No. 440007773
IMPORTANT ALLOW FILTER TO DRY COMPLETELY BEFORE REPLACING. DRY FILTER ON EDGE SO AIR CIRCULATES
ON BOTH SIDES OF FILTER. THIS MAY TAKE UP TO 24 HOURS.
To Next Page
Loading...
Need help?
General
