Refer to ‘Selecting the wash programme’ for
details of how to select programmes.
1. Turn on the water supply and check for
leaks from the fill hose.
2. Switch on the electricity supply.
3. Select the spin programme and then
press the button to start the machine.
Allow the programme to continue for one
minute and then cancel the programme by
returning the selector to the OFF position.
This will remove any water remaining in the
machine from factory testing.
4. To check for cold water filling to the
machine:
Select the rinse programme and press
the button to start the machine.
Allow the tumble action to continue until
the water has pumped out. Check that the
drain outlet is not leaking or overflowing.
5. Switch off the machine at the end of the
cycle by turning the programme knob to the
OFF position.
6. Select the spin programme and press
the button to start the machine. If the
machine takes longer than one minute to
empty check the drain hose for kinks.
Installation testing is now
complete.
Now you have successfully installed the machine
we advise that you run the machine to ensure the
drum is thoroughly clean after testing and
storage. Select 90 and run the machine for a
complete cycle using only wash detergent and
water.
12
Testing the installation
This
programme
will take
approximately
2 hours to
complete.
To Next Page
Loading...
Need help?
General