16
Filters
HEPA MEDIA FINAL FILTER
The nal lters assist in the ltration process to return cleaner air to the room. There are 2 HEPA
Filters, one on each side of the backpack.
1
Remove lter door
by pulling rear tab
forward and rotating
out.
2
Pull lter out by the
frame. Hand rinse in
cold water under low
pressure. Rinse only
surface facing inside
of machine. Let dry for
24 hours and reposition
into the lter housing.
3
To replace lter door,
align the two forward
facing tabs and rotate
into place. Press rear
tab until door snaps
into place.
REPLACEMENT FILTER
Inspect HEPA Media Final Filter every month, rinsing when necessary. Check for
wear of media and replace if pleats are damaged. Change lter regularly to maintain
maximum performance.
HEPA Media Final Filter 2 Pack Part No. AH40006
WARNING:
TO REDUCE THE RISK OF PERSONAL INJURY – REMOVE BATTERY BEFORE CLEANING
OR SERVICING. DO NOT OPERATE VACUUM WITHOUT BOTH INLET FILTER AND FINAL FILTERS IN PLACE.
IMPORTANT:
ALLOW FILTER TO DRY COMPLETELY BEFORE REPLACING. DRY FILTER ON
EDGE SO AIR CIRCULATES ON BOTH SIDES OF FILTER. THIS MAY TAKE UP TO 24 HOURS.
To Next Page
Loading...
Need help?
General
