HP 33120A User Manual

Sweep Time
The sweep time specifies the number of seconds required to sweep from
the start frequency to the stop frequency. The number of frequency
points in the sweep depends on the sweep time you select and is
automatically calculated by the function generator.
• Sweep time: 1 ms to 500 seconds. The default is 1 second.
• The function generator computes between 2,048 and 4,096 frequency
points from the start frequency to the stop frequency.
• Front-Panel Operation:
3: SWP TIME (SWP MENU)
• Remote Interface Operation:
SWEep:TIME {<
seconds>|MINimum|MAXimum}
Sweep Mode
You can sweep with either linear or logarithmic spacing. The output
frequency of a linear sweep changes linearly during the duration of the
sweep. For logarithmic spacing, the output frequency changes
exponentially during the duration of the sweep.
• Sweep mode:
Linear or Logarithmic. The default is Linear.
• Front-Panel Operation:
4: SWP MODE (SWP MENU)
• Remote Interface Operation:
SWEep:SPACing {LINear|LOGarithmic}
Chapter 3 Features and Functions
Frequency Sweep
96

HP 33120A Specifications

General

Frequency Range	100 µHz to 15 MHz
Waveforms	Sine, Square, Triangle, Ramp, Arbitrary
Amplitude Range	10 mVpp to 10 Vpp into 50 Ohms
Output Impedance	50 Ohms
Interface	GPIB
Function Generator Type	Arbitrary
Power Requirements	100/120/220/240 VAC ±10%, 50/60 Hz, 60 VA max