Rack-mounting an 3600 v2 switch
This installation task requires two persons. To mount the switch in a rack:
1. Wear an ESD-preventive wrist strap and make sure it makes good skin contact and is well
grounded.
2. Check that the mounting brackets have been securely attached to the switch chassis.
3. Install cage nuts (user-spplied) in the mounting holes in the rack posts.
4. One person holds the switch chassis and aligns the mounting brackets with the mounting holes in
the rack posts, and the other person fixes the mounting brackets with anti-rust screws (user-supplied)
to the rack.
5. Check that the switch chassis is horizontal and tighten the screws.
Figure 20 Mount an 3600 v2 switch in a rack
Mounting the switch on a workbench
If a standard 19-inch rack is not available, you can place an 3600 v2 switch on a clean, flat workbench,
as follows:
1. Check that the workbench is sturdy and well grounded.
13
To Next Page
Loading...
Need help?
General