Figures
l-l. Example of a Static-Safe Workstation
.................
l-2. Spectrum Analyzer Shipping Container and Cushioning Materials
.....
2-l. High Voltage Power Supply Adjustment Setup
.............
2-2. Display Adjustment Setup
......................
2-3. CRT Adjust Pattern
........................
2-4. A2 Display Adjustment Locations
...................
2-5. IF
Bandpass
Adjustment Setup
....................
2-6. TAM Connector Pin Locations
....................
2-7. IF Amplitude Adjustment Setup
...................
2-8. IF Amplitude Adjustment Locations
.................
2-9. DC Log Adjustment Setup
......................
2-10. DC Log Adjustment Locations
....................
2-
11. Sampler Adjustment Setup
......................
2-12. TAM Connector Pin Locations
....................
2-13. YTO Adjustment Setup
.......................
2-14. YTO Adjustment Locations
.....................
2-15. First LO Distribution Amplifier Adjustment Setup
...........
2-16. TAM Connector Pin Locations
....................
2-17. Frequency Response Adjustment Setup
................
2-18. Calibrator Amplitude Adjustment Setup
................
2-19. 10 MHz Reference Adjustment Setup and Adjustment Location
......
2-20. 10 MHz Reference Adjustment Setup-TCXO
.............
2-21. Demodulator Adjustment Setup
...................
2-22. Demodulator Adjustment Locations
..................
2-23. External Mixer Bias Adjustment Setup
................
2-24. External Mixer Amplitude Adjustment Setup
..............
2-25. RYTHM Adjustment Setup
.....................
2-26. 16 MHz PLL Adjustment Setup
...................
2-27. 16 MHz PLL Adjustment Location
..................
3-l. Front End Cal Adjustment Setup
...................
4-
1. Hinged Assemblies
.........................
4-2. Discharging High Voltage on the CRT
.................
4-3. A9, A18, and Line-Switch Assembly Mounting Screws
..........
4-4. front frame Mounting Screws
.....................
4-5. Installing the CRT and front frame Assemblies
.............
4-6. Placing the CRT into the Front Frame
.................
4-7. A2, A3, A4, and A5 Assembly Removal
................
4-8. Assembly Cables (1 of 2)
.......................
4-9. Coaxial Cable Clip
.........................
4-10. HP-IB and
AlAl
Wl
Cable Placement
................
4-l 1. A6 Power Supply Connections
....................
4-12. Power Supply Cover
.........................
l-5
l-8
2-13
2-15
2-17
2-19
2-21
2-22
2-26
2-27
2-30
2-31
2-34
2-35
2-37
2-39
2-40
2-41
2-44
2-47
2-49
2-51
2-53
2-55
2-56
2-57
2-60
2-63
2-64
3-15
4-4
4-7
4-8
4-9
4-10
4-11
4-16
4-17
4-19
4-20
4-23
4-24
Contents-l 1
To Next Page
Loading...
Need help?
General
