34 HP Media Center PC Getting Started Guide
Connecting 4.1 (4 Speakers and a Subwoofer) Audio Speakers
To connect two front speakers, two rear speakers,
and a subwoofer for four-channel (4.1 speaker)
output:
1 Turn off the PC.
.
2 Connect the front speaker cable to the lime
green Audio Line Out connector that matches
the back of your PC.
3 Connect the rear speaker cable to the black
connector that matches the back of your PC.
For type 3-connector systems, the blue Audio
Line In connector functions as a Rear Line Out
when a multichannel audio configuration is
activated.
4 Connect the cables to the audio system.
5 Connect the front and rear speakers to the
subwoofer. Refer to the speaker
documentation.
6 Turn on the PC.
7 Plug in the speaker system power.
8 Turn on the speaker system.
9 After the speakers are connected to the PC,
configure the audio software for sound output
for your PC model:
■ Type 3 connectors: See “Configuring
Audio Output with Multi-channel Sound
Manager” on page 42.
■ Type 6 connectors: See “Configuring
Audio Output with Sound Effect Manager”
on page 44.
■ Sound card: See “Configuring Audio
Output with a Sound Card” on page 47.
The following diagram shows a typical 4.1 audio installation:
n
Type 3 is three
connectors
Type 6 is six
connectors
Type S is sound card
OUT
3
6
S
IN
3
6
S
n
Always turn on the
PC before you turn on
the speaker system.
OUT
IN
To Next Page
Loading...
Need help?
General
