3. After the delete command has completed rebuild the storage system using the following
StoreOnce CLI commands to discover and add storage to the system
hardware discover storage
Monitor the status of the LUN creation process using the StoreOnce CLI command:
hardware show storage status
Look for the Formatted and Discovered information under Status. When all the storage
has been discovered, add it to the system.
hardware add storage
This will configure both the storage in the appliance (base storage) and any attached
expansion shelves. Licenses must be present for all attached storage before the command
will complete successfully. If insufficient licenses are available, no storage will be configured.
If multiple disks fail and a RAIDset is broken 53
To Next Page
Loading...
Need help?
General