11
HP Switch zl Modules
Steps to Update the E8212 zl Module Software
1. Copy new software to primary or secondary flash memory on acitive
management module:
USB – E8200zl#copy usb flash K_13_60.swi pri
TFTP – E8200zl#copy tftp flash 192.168.248.10
k_13_60.swi pri
Af
ter downloading a new software version to either the primary or
seco
ndary flash of the active management module, the software version
is immediately copied to the corresponding flash (primary or secondary)
of the standby module unless the standby module failed selftest or
redundancy was disabled with the no redundancy management-module
command.
2. Make sure boot setting is configured t
o
boot to correct flash to which the
software was copied.
E8200zl#boot set-default flash primary
E8200zl#write memory
This c
hange will also be synchronized to standby management module.
3. Boot standby module
E8200zl#boot standby
This does not interrupt current switch operations yet. After the standby
ma
na
gement module has rebooted and is back in standby mode. You can
verify this by using the showredundancy command.
Example during reboot.
ProCurve Switch 8212zl# show redundancy
Settings
--------
Mgmt Redundancy
: Enabled
Statistics
----------
Failovers : 3
Last Failover : Tue May 12 17:30:07 2009
Slot Module Des
cription Status SW Version Boot Image
---- ---------------------------------------- --------
MM1 ProCurve J9092A Management Module
E8200zl Unknown
MM2 ProCurve J9092A Management Module E8200zl Active K.13.60
Secondary
To Next Page
Loading...
Need help?
General
