22
Installing the Modules
Install or Remove an X2 Transceiver
Note Hot swapping transceivers is supported. You can install or remove a trans-
ceiver with the switch powered on, a reset will not occur.
a. Slide the transceiver in until it stops.
b. Pu
sh firmly until the gasket seats against the bulkhead.
Note When switch power is on, the Link and Mode LEDs will come on for approx-
imately two seconds and then go off. This is confirmation the transceiver is
co
mpletely seated.
c. If your transceiver has a bail, move the bail up, if not your transceiver is
now completely installed.
To remove the X2 transceiver:
If your transceiver has a bail, lower the bail until it is approximately horizontal,
and then using the bail, pull the transceiver from the slot. If your transceiver
does not have a bail, pull the transceiver straight out.
To Next Page
Loading...
Need help?
General
