16
Version KA.15.03.3007
Status: Released and fully supported, but not posted on the Web.
The following problem was resolved in software version KA.15.03.3007.
■ CLI (CR_0000108615) - The output of the show tech all command stops after the show interfaces section.
Version KA.15.03.3008
Status: Released and fully supported, but not posted on the Web.
The following problem was resolved in software version KA.15.03.3008.
■ Event Log (CR_0000110967) - The switch calculates internal parity errors incorrectly, which causes event log
messages similar to parity recovery 1553 0x80000c0a.
Version KA.15.03.3009
Status: Never released.
The following problems were resolved in software version KA.15.03.3009.
■ Crash (CR_0000107764) - With VRRP enabled, a switch might crash again during bootup after a crash.
■ Event Log (CR_0000110723) - The error message: IpAddrMgr: STI-CMDR: FAILED - Module 3\ BMP
TCAM, parity recovery 0x80000000 0x00000000 appears in the event log.
■ Management (CR_0000106958) - After multiple TELNET and SSH sessions are opened and then closed in rapid
succession, the switch might not allow a new management connection to open even though there are available
sessions, responding with the error message: Sorry, the maximum number of sessions are active.
Try again later.
■ Stacking (CR_0000111105) - The output of show tech does not include information about stack members.
■ Stacking (CR_0000111563) - The output of show tech does not include adequate information about the stacking
link between stack members.
■ Switch Hang (CR_0000109565) - The switch might fail to boot fully, requiring a power-cycle to recover.
Version KA.15.03.3010
Status: Released and fully supported, but not posted on the Web.
The following problem was resolved in software version KA.15.03.3010.
■ Switch Hang (CR_0000112490) - The switch becomes unresponsive during output of the show tech all command.
Output halts after issuing the stackingshowtech command on a Member.
To Next Page
Loading...
Need help?
General
