5
CDPv2 Transmit Capability
■ Enhancement (CR_0000107011) - When a Cisco VoIP phone boots up (or sometimes periodically), it queries the
switch and advertises information about itself using CDPv2. The switch receives the VoIP VLAN Query TLV (type
0x0f) from the phone and then immediately sends the voice VLAN ID in a reply packet to the phone using the VLAN
Reply TLV (type 0x0e). The phone then begins tagging all packets with the advertised voice VLAN ID.
CLI
Comware CLI Commands in ProVision Software
■ Enhancement (CR_0000106070)—The is the first of several phases that allows a Comware CLI proficient user to
use their Comware CLI knowledge to generate equivalent ProVision software CLI commands to manage and configure
ProVision software switches. This preliminary offering adds 21 simple Comware Display commands directly to the
ProVision CLI, with additional troubleshooting and management commands planned for future software versions.
See the Comware CLI Commands in ProVision Software manual for more details.
Comware CLI Commands in ProVision Software (Phase 2)
■ Enhancement (CR_0000114497) - This is the second of several phases that allows a Comware CLI proficient user
to use their Comware CLI knowledge to effectively manage and configure ProVision software switches. This phase
adds 112 additional Comware display commands to the ProVision software CLI.
Terminal Line Width and Length
■ Enhancement (CR_0000074537) - For console/serial link and inbound telnet sessions, the switch output:
• Uses whatever width is set by the terminal program. If width is not specified, 80 characters is the default.
• Automatically wraps on word boundaries (such as spaces) for non-columnar output
• Automatically wraps on column boundaries for columnar output
HP recommends that you do not set your terminal width (terminal width <y>) above 150 columns.
Config
Customized Commands for Local User Accounts
■ Enhancement (PR_0000069000)—Provides additional control over user access to the switch by creating local
user accounts that are authorized to use a customized set of commands. See “RADIUS Authentication, Authorization,
and Accounting” in the Access Security Guide.
Custom Default Configuration
■ Enhancement (PR_0000045685)—Allows creation of a custom default configuration for the switch. For more
information, see the chapter “Switch Memory and Configuration” in the Basic Operation Guide for your switch.
Mesh ID
■ Enhancement (PR_0000093199, CR_0000093199)—Adds the ability to configure a mesh ID. See the Advanced
Traffic Configuration Guide, “Switch Meshing” chapter.
Grouped Config File Display
■ Enhancement (PR_0000071901)—When executing the show config or show running-config commands, interfaces
that have configuration settings are displayed together in order, only once, containing all the configuration commands
for that interface. For more information, see the chapter “Switch Memory and Configuration” in the Basic Operation
Guide for your switch.
To Next Page
Loading...
Need help?
General
