Go to cover page
Warning Message
HP L2025
HP L1502 LCD
6
Warning Message Table
Item Attention Signals Display Time Condition
1 Input Signal out of Range See power saver table
2 No Input Signal See power saver table
3 Going to Sleep See power saver table
4 Adjusting.... Auto hot key or OSD menu function
5 OSD Lockout 10secs Push menu key for 10 sec then display 10 sec WM"OSD
Lockout"
6 Check Video Cable See power saver table
Power Saver - On Power Saver - Off Note
Quit signal with
cable
1. System blank and show WM
"Going to Sleep"3 sec then sleep.
1. System blank and show moving
WM "No Input Signal" always.
Disconnect cable 1. System blank and show WM
"Check Video Cable" 10
1. System blank and show WM
"Check Video Cable" 10
sec then moving about 50 sec. 2.
Show WM "Going to Sleep" 3 sec
then sleep. 3. If push any key in
sleep mode, then repeat item 1 to
2.
sec then moving always.
Out of range - 1 1. System blank and show moving
WM "Input Signal out of Range"
60 secs. 2. Show WM "going to
Sleep" 3 sec then sleep. 3. If push
any key in sleep mode, then
repeat item 1to 2.
1. System blank and show moving
WM "Input Signal Out of Range"
always.
H<29.5 or
H>82.5 or V<49
or V>87 or
Vtotal>=120 0
Out of range - 2 1. Show moving WM"Input Signal
out of Range" 60 sec.
1. Show moving WM "Input Signal
out of Range"60 sec.
DownScaling
Ex. 1280x1024
2. Menu key can active during
moving WM and operate OSD
menu. 3. WM disappear if menu
key push or after WM 60 sec.
2. Menu key can active during
moving WM and operate OSD
menu. 3. WM disappear if menu
key push or after WM 60 sec.
Out of range - 3 1. Show moving WM "Input Signal
out of Range" 60 sec.
1. Show moving WM "Input Signal
out of Range" 60 sec.
85Hz
2. After moving WM 60 sec then
show WM "Going to Sleep" 3 sec
then sleep. 3. If push any key in
sleep mode, then repeat item 1 to
2.
2. After moving WM 60 sec then
show WM "Going to Sleep"3 sec
then sleep. 3. If push any key in
sleep mode, then repeat item 1 to
2.
Power saver table
To Next Page
Loading...
Need help?
General
