Turning on the Monitor
1.
Press the power switch to turn on the computer.
2.
Press the power button on the front of the monitor.
CAUTION: Burn-in image damage may occur on monitors that display the same static image on
screen for a prolonged period of time.* To avoid burn-in image damage on the monitor screen,
you should always activate a screen saver application or turn off the monitor when it is not in use
for a prolonged period of time. Image retention is a condition that may occur on all LCD screens.
* A prolonged period of time is 12 or more consecutive hours of non-use.
Mounting Solutions
Removing the Monitor Pedestal Base
You can remove the monitor panel from the pedestal base to mount the panel on a wall, a swing arm, or
other mounting fixture.
CAUTION: Before beginning to disassemble the monitor, be sure the monitor is turned off and
the power and signal cables are both disconnected. If the monitor has a connected audio cable,
disconnect it.
1.
Disconnect and remove the signal and power cables from the back of the monitor.
2.
Adjust the monitor height to its highest position.
3.
Press the Quick Release lever all the way to the right (1) then slide the monitor up and off the pedestal
base (2).
Figure 3-11 Removing the Monitor from the Pedestal Base
ENWW Turn
ing on the Monitor 11
To Next Page
Loading...
Need help?
General
