Operating the Monitor
✎
When adjusting the Clock and Clock Phase values, if the monitor
images become distorted, continue adjusting the values until the
distortion disappears. To restore the factory settings, select Yes
from the Factory Reset menu in the on-screen display.
Identifying Monitor Conditions
Special messages will appear on the monitor screen when
identifying the following monitor conditions:
■ Input Signal Out of Range— Indicates the monitor does not
support the input signal because the resolution and/or refresh
rate are set higher than the monitor supports. Set the
resolution and refresh rate for 1280 x 1024 at 60 Hz. Restart
your computer for the new settings to take effect.
■ Monitor Going to Sleep— Indicates the screen display is
entering a sleep mode.
■ Check Video Cable— Indicates the video cable is not
properly connected to the computer.
■ OSD Lock—The OSD can be enabled or disabled by pressing
and holding the Menu button on the front panel for 10
seconds. If the OSD is locked, the warning message “OSD
Lock” displays for ten seconds.
❏ If the OSD is locked, press and hold the Menu button for
10 seconds to unlock the OSD.
❏ If the OSD is unlocked, press and hold the Menu button
for 10 seconds to lock the OSD.
User Guide 4–11
To Next Page
Loading...
Need help?
General
