TouchPad button board
Description Spare part number
TouchPad button board 651901-001
Before removing the TouchPad button board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
Battery on page 37).
5. Remove the following components:
a. Service access cover (see
Service access cover on page 38).
b. Keyboard (see
Keyboard on page 48).
c. Top cover (see
Top cover on page 54).
Remove the TouchPad button board:
1. Turn the top cover upside down, with the front toward you.
2. Release the TouchPad button board ZIF connector (1), and then disconnect the TouchPad
button board cable (2).
3. Remove the two Phillips PM2.0x3.0 screws (3).
4. Remove the TouchPad button board (4).
58 Chapter 4 Removal and replacement procedures
To Next Page
Loading...
Need help?
General