Replacing or upgrading the hard drive
CAUTION: To prevent information loss or an unresponsive system:
Shut down the computer before removing the hard drive from the hard drive bay. Do not remove the
hard drive while the computer is on, in the Sleep state, or in Hibernation.
If you are not sure whether the computer is off or in Hibernation, turn the computer on by pressing the
power button. Then shut down the computer through the operating system.
Removing the hard drive
1. Save your work and shut down the computer.
2. Disconnect AC power and external devices connected to the computer.
3. Turn the computer upside down on a flat surface.
4. Remove the battery.
5. Slide the battery/service door latch (1) to release the service door.
6. Slide the service door toward the front of the computer (2), and then lift the door to remove it (3).
7. Lift the hard drive connector cable (1) until it disconnects from the computer.
8. Remove the Phillips screw (2) that secures the hard drive to the computer.
Replacing or upgrading the hard drive 27
To Next Page
Loading...
Need help?
General