Solid state drive
Description Spare part number
M.2 SATA SSD, PCIe NVMe TLC
●
512 GB 2280 M2 PCIe 3x4SS NVMe TLC PA 847110-004
●
256 GB 2280 M2 PCIe 3x4SS NVMe TLC PA 847109-002
●
128 GB 2280 M2 3x4SS Value PA 912322-005
●
16 GB 2280 M2 3x4SS Value PA L09145-014
Before removing the SSD, follow these steps:
1. Turn o the computer. If you are unsure whether the computer is o or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by rst unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
3. Disconnect all external devices from the computer.
4. Remove the following components:
a. Base enclosure (see Base enclosure on page 45)
b. Battery (see Battery on page 38)
Remove the SSD:
1. Remove the Phillips screw (1) that secures the SSD to the system board.
2. Remove the SSD (2) by pulling the drive away from the slot at an angle.
Reverse this procedure to install the SSD.
44 Chapter 5 Removal and replacement procedures for Customer Self-Repair parts
To Next Page
Loading...
Need help?
General
