Speakers
NOTE: The speaker spare part kit includes the cable.
Description Spare part number
Speaker Kit (includes right and left speakers) 931598-001
IMPORTANT: Make special note of each screw and screw lock size and location during removal
and replacement.
Before removing the speakers, follow these steps:
1. Shut down the computer.
2. Disconnect the power from the computer by rst unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
3. Disconnect all external devices connected to the computer.
4. Remove the following components:
a. Base enclosure (see Base enclosure on page 45)
b. Battery (see Battery on page 38)
Remove the speakers:
1. Carefully disconnect the speaker connector (1) from the system board.
2. Release the display cable from the routing channels (2).
3. Remove the Phillips M2.0x4 screw and Phillips M2.5x5 screw (3).
4. Lift the left and right speakers (4) to remove them.
Reverse this procedure to install the speakers.
Component replacement procedures 47
To Next Page
Loading...
Need help?
General
