Power in connector
Description Spare part number
For use only on products with 135 or 150 W AC adapter and NV N17P (GTX 1050/GTX 1050Ti) processors 926204-002
For use only on products with 230 W adapter AC adapter GPU NV N17E (GTX1070/GTX1060) processors 926564-001
Before removing the power in connector, follow these steps:
1. Turn o the computer. If you are unsure whether the computer is o or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by rst unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
3. Disconnect all external devices from the computer.
4. Remove the following components:
a. Base enclosure (see Base enclosure on page 45)
b. Battery (see Battery on page 38)
c. Speakers (see Speakers on page 47).
d. Optical drive (see Optical drive on page 48)
e. Remove the fans (see Fans on page 53)
f. Remove the heatsink (see Heat sink on page 54)
g. Remove the system board (see System board on page 57)
Remove the power in connector:
1. Remove the two Phillips screws securing the connector and bracket to the computer (1).
60 Chapter 6 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
Need help?
General
