46 Advanced Setup Guide (features vary by model)
Wall to cable TV set-top box or satellite box to
VCR and TV, using S-video cable or composite
video cable between the box and the VCR or TV
1 Do not detach any cables from the existing setup.
2 Connect an additional cable by doing one of the following:
Connect one end of an S-video cable (not included) to a second output on the
set-top box or satellite box. Connect the other end to the S-video In connector on
the back of the computer.
Or
Connect one end of a composite video cable to a second output on the set-top box
or satellite box. Connect the other end to the S-video-to-composite video adapter
cable, and then connect the adapter to the S-video In connector on the back of the
computer.
3 If you are using a composite video or S-video cable, you must also connect audio
cables (not included) from the satellite box or set-top box to the Audio In right (red)
and Audio In left (white) connectors on the back of the computer.
4 Connect the remote control sensor cable (emitter), and position it on the set-top box or
satellite box. This enables the computer to change the channel on the box. See
“Connecting the Remote Sensor.”
To Next Page
Loading...
Need help?
General