Navigating and selecting in Setup Utility (BIOS)
To navigate and select in Setup Utility (BIOS), follow these steps:
1. Turn on or restart the computer, and then press esc while the “Press the ESC key for Startup
Menu” message is displayed at the bottom of the screen.
● To select a menu or a menu item, use the tab key and the keyboard arrow keys and then
press enter.
●
To scroll up and down, use the up arrow key or the down arrow key.
● To close open dialog boxes and return to the main Setup Utility (BIOS) screen, press esc,
and then follow the on-screen instructions.
2. Press f10 to enter Setup Utility (BIOS).
To exit Setup Utility (BIOS) menus, choose one of the following methods:
● To exit Setup Utility (BIOS) menus without saving your changes, press the esc key, and then
follow the on-screen instructions.
– or –
Use the arrow keys to select Exit > Exit Discarding Changes, and then press enter.
– or –
●
To save your changes and exit Setup Utility (BIOS) menus, press f10, and then follow the on-
screen instructions.
– or –
Use the arrow keys to select Exit > Exit Saving Changes, and then press enter.
Your changes go into effect when the computer restarts.
Displaying system information
1. Start Setup Utility (BIOS).
2. Select the Main menu. System information such as the system time and date, and identification
information about the computer is displayed.
3. To exit Setup Utility (BIOS) without changing any settings, use the arrow keys to select Exit >
Exit Discarding Changes, and then press enter.
Restoring factory settings in Setup Utility (BIOS)
NOTE: Restoring defaults will not change the hard drive mode.
To return all settings in Setup Utility (BIOS) to the values that were set at the factory, follow these
steps:
1. Turn on or restart the computer, and then press esc while the “Press the ESC key for Startup
Menu” message is displayed at the bottom of the screen.
2. Press f10 to enter Setup Utility (BIOS).
Using Setup Utility (BIOS) 85
To Next Page
Loading...
Need help?
General