6-14 Cursor Positioning EN
Line Termination Command
The Line Termination command controls the way the printer interprets
CR, LF, and FF control characters. All CR, LF and FF control
characters received after the Line Termination Command are
interpreted as shown below.
? & k # G
# = 0- CR=CR; LF=LF; FF=FF
1 - CR=CR-LF; LF=LF; FF=FF
2 - CR=CR; LF=CR-LF; FF=CR-FF
3 - CR=CR-LF; LF=CR-LF; FF=CR-FF
Default = 0
Range = 0-3
For example, if a value field of 1 is sent, the printer interprets each
Carriage Return (CR) received as a Carriage Return (CR) and Line
Feed (LF) control code. A Line Feed or Form Feed would be sent
as is.
If a value of 3 is sent, the printer interprets each Carriage Return (CR)
received as a Carriage Return (CR) and Line Feed (LF); it interprets
each Line Feed (LF) received as a Carriage Return (CR) and Line
Feed (LF); and it interprets each Form Feed (FF) received as a
Carriage Return (CR) and Form Feed (FF).
To Next Page
Loading...
Need help?
General
