EN Pattern ID (Area Fill ID) Command 14-5
Pattern ID (Area Fill ID) Command
The Pattern ID command (formerly called Area Fill ID) identifies the
specific shading, cross-hatch, or user-defined pattern (see Figure
14-2) to be used when filling a rectangular area.
E
C
* c # G
Default = 0 (no pattern)
Range = 0 - 32767 (values outside the range are ignored)
The value field (#) identifies the level of shading, the cross-hatch
pattern, or the user-defined pattern.
There are eight HP defined shading patterns defined within the PCL
language. To specify one of the eight shading patterns, use any value
within the value field range for the desired shade. For example, to
select the 56-80% shade (shown in Figure 14-1) use a value of 56,
or 80, or any value in between such as 73.
Table 14-1
Selecting Shaded Patterns
Selecting Cross-Hatch
patterns:
# = 1 thru 2 = 1- 2% shade # = 1 - Pattern #1
3 thru 10 = 3-10% shade 2 - Pattern #2
11 thru 20 = 11-20% shade 3 - Pattern #3
21 thru 35 = 21-35% shade 4 - Pattern #4
36 thru 55 = 36-55% shade 5 - Pattern #5
56 thru 80 = 56-80% shade 6 - Pattern #6
81 thru 99 = 81-99% shade
100 = 100% shade
Selecting User-Defined patterns:
1
1. Not supported on all LaserJet family printers. Refer to the “PCL Feature Support
Matrix” in Chapter 1 of the PCL 5 Comparison Guide for specifics.
# = ID number of user-defined pattern
To Next Page
Loading...
Need help?
General
