EasyManuals Logo
Home>HP>Switch>ProCurve 2610

HP ProCurve 2610 Installation And Getting Started Guide

HP ProCurve 2610
112 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #43 background imageLoading...
Page #43 background image
2-19
Installing the Switch
Installation Procedures
Installing the Switch
The 600 RPS/EPS provides two types of power to the
switches:
Redundant power to one of up to six switches, to back up the internal
switch power supply in case of AC power loss, or a fault condition. Should
the internal switch power supply fail, power will be supplied from the 600
RPS/EPS, if it is available, that is, if the 600 RPS/EPS is not already
providing power to a higher priority switch. See the documentation that
came with your 600 RPS/EPS for more information.
External Power-over-Ethernet (PoE) power to up to two switch products.
The 600 RPS/EPS can supply 408 watts of PoE power to the switch if the
internal PoE power supply should fail. For the Switch 2610-24/12PWR and
2610-48-PWR the external PoE power is additional power made available
to the switchs ports. For further information regarding the 600 RPS/EPS
PoE capabilities, see the PoE Planning and Implementation Guide and
the ProCurve 600/610 External Power Supplies Installation and Getting
Started Guide, which is on the ProCurve Web site at www.hp.com/go/
procurve/manuals, (See page 1-13).
The 600 RPS/EPS is an unmanaged power supply that only provides
information by way of LEDs.
The 610 EPS only provides external PoE power:
External Power-over-Ethernet (PoE) power to up to four switch products.
The 610 EPS can supply 408 watts (if one port of a pair is used) or 204
watts (if two ports of a pair are used) of PoE power to the switch if the
internal PoE power supply should fail. For the Switch 2610-48-PWR the
external PoE power is additional power made available to the switchs
ports. For further information regarding the 600 RPS/EPS and the 610 EPS
PoE capabilities, see the PoE Planning and Implementation Guide and
the ProCurve 600/610 External Power Supplies Installation and Getting
Started Guide, which is on the ProCurve Web site at www.hp.com/go/
procurve/manuals, (See page 1-13).
The 610 EPS is an unmanaged power supply that only provides informa-
tion by way of LEDs.
RPS/EPS Operation
The RPS/EPS monitors the power signal from the switch by detecting that the
RPS/EPS is connected to a switch with an RPS/EPS cable. When the power
from the switch is no longer detected, the RPS/EPS will provide power to the
switch within 1 millisecond.

Table of Contents

Other manuals for HP ProCurve 2610

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP ProCurve 2610 and is the answer not in the manual?

HP ProCurve 2610 Specifications

General IconGeneral
BrandHP
ModelProCurve 2610
CategorySwitch
LanguageEnglish

Related product manuals