HP Thin Client T740 User Manual

NOTE: An optional Quick Release mounting bracket is available from HP for mounting the thin client to a
wall, desk, or swing arm. When the mounting bracket is used, do not install the thin client with the I/O ports
oriented towards the ground.
Connecting the AC power cord
1. Connect the round end of the power supply cord to the power supply connector on the rear of the thin
client (1).
2. Use the slot (2) on the side of the retractable AC power cord retention hook to pull the hook out.
3. Press the AC power cord into the retention hook (3) and bundle any excess AC power cord.
4. Plug the female end of the AC power cord into the power supply brick (4).
5. Connect the other end of the AC power cord to an AC outlet (5).
CAUTION: Failure to secure the power cable with the retention hook may result in the AC power cord
becoming disconnected, causing loss of data.
8 Chapter 2 Setup

HP Thin Client T740 Specifications

General

Brand	HP
Model	Thin Client T740
Category	Desktop
Language	English