To Next Page

To Previous Page

User’s Guide 3–1

Setting Up the Monitor

Unpacking the Monitor

1. Unpack the monitor. Make sure all contents are included. Store the packing box.

2. Turn off the computer and other attached devices.

3. Determine whether the monitor will be desktop mounted or wall-mounted. See “Installing the Monitor.”

4. Prepare a flat area to assemble the monitor. You may need a flat, soft, protected area for placing the monitor

screen-down while preparing it for installation.

5. You need a Phillips screwdriver for preparing the monitor for wall-mounting. You may need a straight-slot

screwdriver to secure some cables.

Installing the Monitor

You can install the monitor on a desktop or wall-mount it. Place the monitor in a convenient, well-ventilated location

near your computer.

If the monitor will be installed on a:

■ Desktop or table, see “Installing on a Desktop.”

■ Wall, swing arm, or other mounting fixture, see “Wall-Mounting the Monitor (Mounting Fixture not Supplied).”

Connect the monitor cables after you have installed the monitor.

Installing on a Desktop

Follow the instructions for your monitor type.

Other manuals for HP W1907

Questions and Answers:

Need help?

Do you have a question about the HP W1907 and is the answer not in the manual?

General

Pixel pitch	0.285 x 0.285 mm
Display diagonal	19 \
Display resolution	1440 x 900 pixels
Viewable size diagonal	483 mm
Contrast ratio (typical)	1000:1
Digital vertical frequency	55 - 75 Hz
Digital horizontal frequency	30 - 83 kHz
Power requirements	100-240VAC
HDCP	Yes
Certification	FCC Class B
Product color	Silver
Country of origin	China
Market positioning	-
Panel mounting interface	100 x 100 mm
Power consumption (standby)	2 W
Power consumption (typical)	49 W
Storage temperature (T-T)	-20 - 60 °C
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	15 - 90 %
Sustainability certificates	ENERGY STAR