4. Use the left and right arrow keys to select the appropriate heading. Use the up and down arrow
keys to select the option you want, and press Enter.
5. To apply and save changes, select File>Save Changes and Exit.
●
If you have made changes that you do not want applied, select File>Ignore Changes and
Exit.
●
To reset to factory settings, select File>Default setup>Restore Factory Settings as
Default. Press F10 to accept the changes. Click Apply Defaults and Exit. This option
restores the original factory system defaults.
CAUTION Do not turn the workstation power off while the ROM is saving your Computer Setup
(F10) Utility changes because the CMOS could become corrupted. After you exit the F10 Setup
screen, it is safe to remove all power from the workstation.
Computer Setup (F10) Utility menu
NOTE The following content is subject to change with new BIOS releases, so your menu may
be different than shown in Table 1–1.
Table 3-1 Computer Setup (F10) Utility menu descriptions
Heading Option Description
File System
Information
Lists product name, SKU number, processor type/speed/stepping, cache size (L1/L2), memory
type and size, integrated Media Access Control (MAC) for enabled or embedded Network Interface
Card (NIC), if applicable, system BIOS type, chassis serial number, and asset tracking number.
About Displays copyright information.
Set Time and
Date
Enables you to set system time and date.
Flash System
ROM
Enables you to flash (update) system BIOS using any supported removable mass storage device
(CD-ROM, USB drive, floppy).
Replicated
Setup
Save to Removable Media
Saves the current F10 Setup configuration to a text file called cpqsetup.txt, which can be used
for Replicated Setup functions.
Restore from Removable Media
Restores previous F10 Setup configuration from a text file called cpqsetup.txt, which can be used
for Replicated Setup functions.
Default Setup Save Current Settings as Default
Stores the current F10 Setup configuration into the physical ROM as the default.
Restore Factory Settings as Default
Restores the original factory settings to the F10 Setup configuration information in the physical
ROM as the default.
Apply Defaults
and Exit
Saves the selected default settings (previously-saved user settings or factory settings) into Non-
Volatile Random Access Memory (NVRAM) and exits.
Ignore
Changes and
Exit
Exits the Computer Setup (F10) Utility without applying or saving any changes.
26 Chapter 3 System management ENWW
To Next Page
Loading...
Need help?
General