HP Xw8400 - Workstation - 4 GB RAM User Manual

2. For short or tall PCI cards, attach the hooks of the PCI retainer (1) under the slots on the rear of
the chassis, and then rotate the retainer down until the retainer arm (2) supports the card.
Figure 4-19 Installing the short or tall card PCI retainer
PCI retention clamp
1. Disconnect power from the system ( Pre-disassembly procedures on page 55), and remove the
access panel (
Access panel on page 60). Place the workstation on its side with the system board
facing up.
2. Open the PCI retention clamp by pressing down on the two green clips at the ends of the clamp
and rotating the clamp toward the back of the system.
Figure 4-20 Opening the PCI retention clamp
ENWW Removing and replacing components 73

HP Xw8400 - Workstation - 4 GB RAM Specifications

General

Brand	HP
Model	Xw8400 - Workstation - 4 GB RAM
Category	Desktop
Language	English