4. Lift the DIMM straight up, and remove it from the unit.
Figure 4-14 Removing DIMM
NOTE DIMMs and DIMM sockets are keyed for proper installation. Be sure these guides align
when installing a DIMM.
Installing memory module
CAUTION HP only ships DIMMs that are electrically and thermally compatible with this product.
Because third-party DIMMs might not be electrically or thermally compatible, they are not
supported by HP.
You must load memory modules in valid configurations:
●
If loading only one DIMM, install it in slot 1. Otherwise, DIMMs must be loaded as matched pairs.
●
If loading two DIMMs, install them in slots 1 and 3.
●
If loading four DIMMs, install them in slots 1, 3, 5, and 7.
●
If loading six DIMMs, install them in slots 1 through 5, and 7.
●
If loading eight DIMMs, install them in all slots.
ENWW Removing and replacing components 69
To Next Page
Loading...
Need help?
General