WARNING! Before removing the workstation access panel, be sure that the workstation is
powered off and that the power cord is disconnected from the electrical outlet.
1. Disconnect power from the system.
2. If a lock is present, unlock the access panel. The keys are on the rear panel (
Rear panel
components on page 4). Also, unlock any other locks that are present (Kensington, or Padlock).
3. Pull up on the handle and lift off the cover.
Figure 4-5 Opening the access panel
To replace the access panel, align the bottom groove of the side panel with the bottom edge of the
chassis. Rotate the side panel toward the chassis and press firmly until the latch engages.
Front bezel
To remove the front bezel:
1. Lift up on the three (1) tabs located on the front bezel.
2. Rotate the front bezel away (2) from the chassis, and remove the bezel.
ENWW Removing and replacing components 61
To Next Page
Loading...
Need help?
General