5. Slide the stand out of the recess (3).
Mounting the Monitor
The monitor panel can be attached to a wall, swing arm, or other mounting fixture.
You can attach the monitor panel to a mounting fixture using the HP Quick Release 2 mounting
bracket or you can attach the monitor panel to a mounting fixture without the HP Quick Release 2
mounting bracket.
NOTE: This apparatus is intended to be supported by UL or CSA Listed wall mount bracket.
CAUTION: This monitor supports the VESA industry standard 100 mm mounting holes. To attach a
third-party mounting solution to the monitor, four 4 mm, 0.7 pitch, and 10 mm long screws are
required. Longer screws must not be used because they may damage the monitor. It is important to
verify that the manufacturer’s mounting solution is compliant with the VESA standard and is rated to
support the weight of the monitor display panel. For best performance, it is important to use the power
and video cables provided with the monitor.
16 Chapter 2 Setting Up and Using the Monitor
To Next Page
Loading...
Need help?
General
