Technical Manual
Airbridge BTS3606A CDMA Base Station
System Description
Chapter 4 Main Functions
4-2
As the CDMA2000 1x system supports the high-speed data service, the
requirement on forward power control becomes higher.
The forward quick power control can control the transmit power of forward channel
accurately. As a result, the interference is reduced and the capacity is increased.
II. Reverse power control
Reverse power control includes open-loop power control and closed-loop power
control. The closed-loop power control can be further classified into inner-loop power
control and outer-loop power control.
l Open-loop power control
The MS determines the transmit power to access the BTS according to the
strength of the received pilot signal.
l Close-loop power control
The BTS issues a power control command to the MS, and makes further
adjustment according to the feedback from the MS.
Figure 4-1 illustrates the principle of closed-loop power control.
MS
BTS
BSC
Eb/Nt
FER
Power Control Bit
Eb/Nt changing
quantity
Inner loop
Outer loop
Figure 4-1 Close-loop power control
In the inner-loop power control, the BTS issues the power control bit according to the
received Eb/Nt value.
In the outer-loop power control, the BSC adjusts the Eb/Nt value according to the
Frame Error Rate (FER) of the received reverse signal. Then the BTS uses the newly
set Eb/Nt value to issue the power control bit. In this way, the transmit power of the MS
can be controlled.
III. Rate control (only applied to 1xEV-DO forward link)
1) Forward link
The AT controls the rate of the forward traffic channel through Data Rate Control
(DRC) channel assignment.
2) Reverse link
To Next Page
Loading...
Need help?
General
