Type Color Status Description
Alarm Green Blinking
once every
0.25s (4
Hz)
l The software is being upgraded.
l After the software is uploaded and started, the AP
working in Fit AP mode requests to go online on
the AC and maintains this state until it goes
online successfully on the AC (before the
CAPWAP link is established).
l The AP working in Fit AP mode fails to go online
on the AC (the CAPWAP link disconnects).
Fault Red Steady on A fault that affects services has occurred, such as a
DRAM detection failure or system software loading
failure. The fault cannot be automatically rectified
and must be rectified manually.
Link indicator
Table 1-4 Descriptions about the Link indicator
Type Color Status Description
LINK Green Steady on The system is running properly, the Ethernet
connection is normal, and no data is being
transmitted.
ACT Green Blinking The system is running properly, the Ethernet
connection is normal, and the AP is transmitting
data. The indicator blinks more quickly when more
data is being transmitted.
Wireless indicator
Table 1-5 Traffic volume indicator
Color Status Description
Yellow/green Off Radios are disabled, and no STA is connected
to the AP.
Yellow/green Steady on The AP has STAs connected to the 2.4 GHz
radio or 5 GHz radio, but no data is being
transmitted.
Huawei AP3x10xN&5x10xN&5x30xN&6x10xN&7x10xN
Hardware Installation and Maintenance Guide 1 Indoor AP Overview
Issue 11 (2015-05-18) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5
To Next Page
Loading...
Need help?
General
