No. Check Item
7 The working ground, protection ground, and surge protection ground share
the same group of ground bars.
8 Connectors of signal cables are complete, intact, and tightly connected.
The signal cables are not damaged or broken.
9 Labels on cables, feeders, or jumpers are clear and correct.
2.9 Powering on the AP
Indoor APs support the DC power supply and PoE power supply. You can select the power
supply mode as required.
Checking Before Power-on
After the AP installation is complete, check the following items before powering on the AP:
l The AP is correctly connected to the power adapter if it uses the DC power supply.
l The PoE power supply device is well grounded if the AP uses the PoE power supply.
NOTE
l The AP6010DN-AGN, AP6010SN-GN, and AP6310SN-GN cannot use the PoE power supply and DC
power supply simultaneously.
l Do not frequently power on and off an AP.
Indicator Status
You can check the power-on status by observing indicators on the AP. For details, see 1.2
Indicator Description.
Huawei AP3x10xN&5x10xN&5x30xN&6x10xN&7x10xN
Hardware Installation and Maintenance Guide 2 AP Installation
Issue 11 (2015-05-18) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
30
To Next Page
Loading...
Need help?
General
