7
Step 2 Enable the WPS negotiation function on the computer within 2
minutes.
Wait for a while (about 10~120 seconds), the WPS indicator on the
HG532t stops blinking and turns steady on (This state for about 300
seconds and then turns off), indicating that a wireless connection is set
up between the HG532t and computer.
3.2 Setting Up a Wireless Connection Manually
If your network adapter does not support the WPS function, you can also set up
a wireless connection manually. The following example uses a computer
running the Window XP operating system to describe how to set up a wireless
connection using the default wireless network name and password:
Step 1
Enable the wireless configuration service provided by Windows XP.
1. Right-click My Computer to display a short-cut menu, and choose
Manage.
2. In the Computer Management window, choose Computer
Management (Local) > Services and Applications > Services.
3. Right-click Wireless Zero Configuration to display a shortcut menu,
and choose Properties.
4. Check that Service status is Started. If Service status is not Started,
click Start.
5. Click OK to close the dialog box, and then close the Computer
Management window.
Step 2
Record the wireless network name and password you set in section
2.2 “Configuring a Dial-up Connection for Internet Access”.
If the default wireless network name and password have been
changed, use the new ones.
Step 3
Configure the wireless network connection on the computer as
follows:
1. Choose Start > All Programs > Accessories > Communications >
Network Connections.
2. In the Network Connections window, right-click Wireless Network
Connection to display a shortcut menu, and then choose Properties.
To Next Page
Loading...
Need help?
General
