3
2 Setting Network Access Parameters
2.1 Logging in to the Web-based Configuration
Utility
Most parameters of the HG658 are pre-set before delivery to meet common
home application scenarios. To check the HG658's working status or configure
certain advanced network functions, use the web-based configuration utility.
To log in to the web-based configuration utility:
Step 1 Open a browser on your computer. Enter http://192.168.1.1 in the
address box, and then press Enter.
Step 2 On the login page, enter your user name (user by default) and
password (HuaweiUser by default).
For safety or convenience reasons, you can change the user name
and password for the web-based configuration utility. For details,
see section
5.1 “Changing the User Name and Password for the
Web-based Configuration Utility”.
If the user name and password are changed, you must use the new
user name and password to log in.
Step 3 Click Login.
After the system verifies your account information, the web-based
configuration utility is displayed.
The first time you log in to the web-based configuration utility, a
setup wizard is displayed. To skip the wizard and go immediately to
the HG658 configuration page, click Advance.
To Next Page
Loading...
Need help?
General
