10
The selected days will show with a to indicate their
status ON. The last is the last watering day for
the program.
Selecting Interval Watering
With this option you can select interval watering from
1 to 31 days.
1. With the
cursor on day 7, press the button until
the interval watering icon and the two calendars
appear on the display.
2. Press the
or button to select the number of
days between watering days (1 to 31). This is called
the interval.
The controller will water the next Start Time and will then
water at the interval programmed.
Programming Stations to Operate Together
(SVC-200 & SVC-400)
The SVC-200 and SVC-400 allow for automatic watering of
multiple valves at the same time. Up to four stations can
operate at the same time. If more than one station has the
same start time, they will operate together (they must also
be programmed with the same water day). For example,
if Station 1 and 2 both have been programmed with start
times of 8:00 am, they will both turn on and run at the
same time.
The SVC allows for start time stacking which is helpful
when system capacity is not adequate to support the opera-
tion of multiple valves at the same time. Let's assume a
scenario in which Station 1 is programmed to start at 8:00
AM and run for 15 minutes, and Station 2 is programmed to
start at 8:10
AM and run for 15 minutes. Station 1 watering
run time overlaps Station 2 start time. The SVC will wait
until Station 1 completes watering until it starts Station 2.
In this scenario, Station 2 will start at 8:15 am.
System Off
This function permits the user to shut the system off for an
indefinite period of time.
1. Press the mode button
until the Crossed Sprin-
kler icon is displayed.
2. Wait 4 seconds and “Off” will appear on the display.
The SVC is now in the System Off mode and will remain
off until it is turned back on again.
PROGRAMMING (Continued)
To Next Page
Loading...
Need help?
General
