11
ENG
To Activate the Controller from the System Off Mode
1. Press the mode button once. The display will wake
up in the System Off mode.
2. Press the mode button
again and “Off” will disappear
from the display. The display will show the current time.
Your controller is now on and will water automatically
based upon the current program.
Programmable Rain Off
This feature permits the user to stop all programmed water-
ings for a designated period from 1 to 7 days. At the end of
the programmable rain off period, the controller will resume
normal automatic operation.
1. Press the
button until the System Off icon is
displayed. Wait 4 seconds and “Off” will appear on
the display.
2. Press the
button and a 1 will be displayed. The 1 will
be blinking at this point.
3. Press the
button as many times as needed to set
the number of days off desired (up to 7). The SVC will
wait the number of days selected and then reactivate
automatic watering.
Manual Watering
The SVC features a simple one touch manual start. One or
more stations can be programmed to run manually at the
same time.
To Activate a Manual Watering:
1. Press the
button once to display the current time
of day.
2. Press and hold the
button for two seconds to display
the Manual Watering icon. The station number will
also be displayed.
3. Use the
or button to adjust the manual water run
time from 1 minute to 4 hours.
4. Release the buttons and the controller will count down
10 seconds before activating the manual cycle.
5. The
flashing sprinkler icon will appear on the display
when watering is occurring.
6. To activate another station, use the
button to select
the station you would like to manually water, repeat
steps 3 and 4.
Note: While manual watering is occurring the display will
briefly display the station number and the time watering
remaining for each station that is operating. The manual
To Next Page
Loading...
Need help?
General
