English – 13
Driving
Before starting
• Read the safety instructions and information concerning
the placement of controls and functions before starting.
• Perform daily maintenance before starting as set out in
the Maintenance schedule.
Adjust the seat to the required position.
Start the engine
1 Rider 111B Make sure that the clutch control is
depressed. (Run position)
2 Lift up the cutting unit by pulling the lever backwards to its
locked position.
3 Activate the parking brake. This is done as follows:
- Press down the parking brake pedal (1).
- Press in the lock button (2) on the steering column.
- Release the brake pedal while holding the button pressed.
The parking brake lock disengages automatically when the
brake pedal is pressed.
Rider 111B5 has the brake pedal and lock button on the right
hand side.
The engine can not be started if the parking brake is not
pressed down.
4 Rider 111 B5
Put the gear shift lever in the ”N” position (neutral).
With a cold engine:
5 Move the throttle to position 3 (choke position). In this
position the engine is f
ed with a richer mixture, which
means the engine is easier to start.
With a warm engine:
6 Move the throttle in between positions 1 and 2.
7 Turn the ignition key to the start position.
8 When the engine starts release the ignition key
immediately bac
k to neutral position.
IMPORTANT!
The air intake grille in the engine cover behind the driver’s
seat must not be blocked by, for example, clothing, leaves,
grass or dirt.
Impaired cooling of the engine. Risk of major engine
damage.
1
2
IMPORTANT INFORMATION
If the engine does not start, wait about 15 seconds before
trying again. If the engine does not start wait about 1 minute
before trying again.
1
3
2
3
1
2
5 Move the throttle to position 3 (choke position). In this
www.devicemanuals.eu
5 Move the throttle to position 3 (choke position). In this
position the engine is f
www.devicemanuals.eu
position the engine is f
ed with a r
www.devicemanuals.eu
ed with a r
position the engine is f
ed with a r
position the engine is f
www.devicemanuals.eu
position the engine is f
ed with a r
position the engine is f
means the engine is easier to start.
www.devicemanuals.eu
means the engine is easier to start.
www.devicemanuals.euwww.devicemanuals.eu
www.devicemanuals.euwww.devicemanuals.eu
2 Lift up the cutting unit by pulling the lever backwards to its
www.devicemanuals.eu
2 Lift up the cutting unit by pulling the lever backwards to its
With a warm engine:
www.devicemanuals.eu
With a warm engine:
www.devicemanuals.euwww.devicemanuals.eu
www.devicemanuals.euwww.devicemanuals.eu
To Next Page
Loading...
Need help?
General
