6.4 Indicator lamp in the charging station
The indicator lamp in the charging station must show a solid or flashing green light for a correct
installation. If not, follow the instructions in the troubleshooting guide below.
You can also find information on www.husqvarna.com. Speak to your Husqvarna
®
customer service for
more information.
Light Cause Action
Green solid light
Good signals. No action required.
Green flashing light
The signals are good and
ECO
mode
is activated.
No action required. For more informa-
tion on
ECO mode
, Refer to
ECO mode
on page 26
.
Blue flashing light
The boundary loop is not connec-
ted to the charging station.
Check that the boundary wire connector
is fitted properly to the charging station.
Refer to
To install the boundary wire on
page 20
.
Break in the boundary loop. Find out where the break is. Replace
the damaged section of the boundary
wire with a new loop wire and splice us-
ing an original coupler. Refer to
Find
breaks in the loop wire on page 42
.
Yellow flashing light
The guide wire is not connected to
the charging station.
Check that the guide wire connector is
properly connected to the charging sta-
tion. Refer to
To install the guide wire
on page 21
.
Break in the guide wire. Find out where the break is. Replace
the damaged section of the guide wire
with a new loop wire and splice using
an original coupler.
Red flashing light
Interruption in the charging sta-
tion’s antenna.
Contact your local Husqvarna
®
repre-
sentative.
Red solid light
Fault in the circuit board or incor-
rect power supply in the charging
station. The fault should be recti-
fied by an authorized service tech-
nician.
Contact your local Husqvarna
®
repre-
sentative.
40 - Troubleshooting 1285 - 004 - 16.04.2020
To Next Page
Loading...
Need help?
General
