Husqvarna Rider 112C User Manual

4 – English
Ser vice journal
Pre-deliver y service
1 Charge the battery for 4 hours at max. 3 amp.
2 Fit steering wheel, seat and any optional equipment.
3 Check and adjust tyre pressure. (60 kPa, 0.6 bar, 9 psi).
4 Check that the right amount of oil is in the engine.
5 Make sure the battery is connected.
6 Fill with fuel and start engine.
7 Check that machine does not move in neutral.
8 Check:
Forward drive.
Reverse drive.
Operation of blades.
Seat safety switch.
Lif lever safety switch.
Safety switch for parking brake.
Check engine speed. See the Technical data section.
9 Tell customer about:
Needs and benefits of following the service schedule.
Servicing and the influence of this journal on the second-hand value of the machine.
Range of applications for BioClip.
Complete proof of sale etc.
Pre-delivery service carried out. No outstanding problems. Certified:
______________________________________________________________________
Date, mileage, stamp, signature
After the fi rst 8 hours
1 Change engine oil

Husqvarna Rider 112C Specifications

General

Engine manufacturer	Briggs & Stratton
Cylinders	1
Transmission type	Hydrostatic
Drive method	Rear-wheel drive
Drive System	Hydrostatic
Transmission	Hydrostatic
Mulching Capability	Yes
Cylinder displacement	344 cc
Cutting methods	Rear discharge
Engine Type	4-stroke
Drive	Rear Wheel Drive
Uncut Circle	30 cm
Fuel Type	Unleaded petrol