REV U 4-2 604220
Lubrication
Use SAE multi-purpose grease.
Electrical System
IMPORTANT: Refer to the Safety section of this manual for
detailed battery servicing safety information.
The electrical system is a 12 volt, negative ground. The
recommended battery size is:
Garden tractor BCI group U1R with a 225 or better
cranking AMP rating.
A maintenance-free battery is recommended. Otherwise,
follow battery manufacturer’s maintenance, safety, storing
and charging specifications.
Master In-Line Fuse
These mowers have a master in-line fuse in the electrical
system. This is the main fuse to protect the complete
electrical system. It is located under the seat platform and
next to the solenoid. Figure 4-1
Hydraulic System
The transmissions are sealed for life and do not require
any scheduled maintenance.
Fuel and Evaporative Emissions Control System
IMPORTANT: Refer to the Safety section of this manual for
fuel handling safety information.
The fuel and evaporative emissions control system for this
mower is EPA compliant. Use only Hustler
®
approved
replacement parts.
Your evaporative emission control system may include
parts such as:
• fuel tanks
• fuel lines
• fuel line fittings
• fuel caps
• carbon canisters
• canister mounting brackets
• carburetor purge port connection
• filters
• vapor hoses
• clamps, control valves
• control solenoids
• electronic controls
• vacuum control diaphragms
• purge valves
• liquid/vapor separator
• other associated components
Modifying or Tampering with the evaporative emissions
control system or the fuel system is prohibited. Federal law
and California State law prohibit the following acts or the
causing thereof:
1. The removal or rendering inoperative by any person
other than for purposes of maintenance, repair,
replacement, of any device or element of design incor-
porated into any equipment for the purposes of emis-
sions control prior to or after its sales or delivery to the
ultimate purchaser or while it is in use, or
2. The use of the equipment after such device or element
of design has been removed or rendered inoperative by
any person.
The fuel tank is located under the seat platform with the
filler neck and fuel cap located in the left side fender.
Figure 4-2
Park the mower on level ground before filling fuel tank.
A. Master fuse housing
Figure 4-1
When washing the mower, direct the spray away
(especially if using a power washer) from the
transaxle’s seals to prevent water intrusion and
ensure component performance.
Use of replacement parts not equivalent to the
original parts may result in system failure and
pose a safety hazard.
To Next Page
Loading...
Need help?
General
