SETUP
0
3-2 powermax1000 Operator Manual
Upon Receipt
1. Check that all items on your order have been received. Contact your distributor/OEM if any items are
missing or damaged.
2. If there is evidence of damage, refer to Claims, below. All communications regarding this equipment
must include the model number and serial number located on the back of the power supply.
3. Read the Safety section of this manual before setting up and operating this Hypertherm system.
Claims
Claims for damage during shipment: If your unit was damaged during shipment, you must file a claim with
the carrier. Hypertherm will furnish you with a copy of the bill of lading upon request. If you need
additional assistance, call the nearest Hypertherm office listed in the front of this manual.
Claims for defective or missing merchandise: If any component is missing or defective, contact your
Hypertherm distributor/OEM. If you need additional assistance, call the nearest Hypertherm office listed in
the front of this manual.
Contents of Box
Verify items against the illustration shown
(for hand system configurations).
Locating Power Supply
Locate the Powermax1000 power supply with at least 10 inches (0.25 m) of open space at the front and
back and fan side of the power supply for proper ventilation.
To Next Page
Loading...
Need help?
General
